About the product
- Overcharge Protection When charging the battery when the voltage reaches the highest battery voltage 42V the protection board will automatically power off and shut down indicating that it will not continue to charge when fully charged form an overcharge protection
- Overdischarge Protection When the battery is about to run out and the voltage is as low as 30V the protection board will also be turned off and can no longer be discharged forming an overdischarge protection effect
- Short Circuit Protection When an accidental short circuit occurs the protection board will automatically shut down within a few milliseconds and will not be powered on again Note that the cell is shortcircuited not through the protection board The protection board will also fail due to continuous high current or the components are heated and damaged
- Charging Method Recommended charging current is 022A with a maximum of 055A Recommended discharge current is 022A the maximum is no more than 055A the protection board is equipped with mos tube the overcurrent protection instantaneous is 1622A and the charging voltage setting is recommended to be 42V
- Widely Application With JST 125 plug these lithium polymer batteries can be used for development board whose plug is SH1252 such as ESP32 LoRa V3 ESP32 LoRa V4 Wireless Tracker Mesh Node T114 Mesh Node T096 and electronic devices
- Note Overcurrent protection is not a panacea please do not continue to charge and discharge with large current or the current and voltage beyond the range otherwise the protection board will be damaged and invalid
